6
ASSEMBLY
NOTE:
●
Do not let the roof rest on the legs until all three legs
●
Attach the bottom cross rails (6) to the legs and cover the joints with the
cross rail clamps (12, 13). Align all holes and insert the fitting (16, 17,18)
(fig. 8). Do not tighten fully at this stage.
8
3
6
18
16
17
6
12
13
●
Repeat the same procedure on the opposite side.
Step 4: Squaring up frame
●
Be sure the frame is standing at the desired location.
●
Level the frame both end-to-end and side-to-side.
●
Check that the frame measures 10' (305 cm) in width (fig. 9).
●
Measure the distance between the interior of the frame feet diagonally.
The sections A to B and C to D should be of equal length (fig. 9). If they
are not of equal length, tap the corner leg of the longer section (using a
rubber mallet) inward until both diagonals are equal.
9
A
B
D
10'
10'
C
Step 5: Anchoring frame
CAUTION!
●
The shed must be well-anchored.
●
Do not attempt to install any of the fabric before the
frame is properly anchored.
●
If the ground is hard or rocky, pre-drill holes before
inserting the anchors.
●
Four anchors (14) are provided to secure the shed. They are to be
installed around the bent corner legs (3) at each corner of the shed.
●
Screw the anchor head into the ground.
●
Insert the cable (23) through the eyelets of the anchor (14) and the bent
corner leg (3). Secure the cable (23) with the cable clamp (24) (fig. 10).
●
Repeat the same procedure for the other three anchors (14).
10
14
3
24
23
Step 3: Attaching bottom cross rails
A
B
D
10'
10'
Step 6: Installing front door and back panels
●
of the front door panel (20) is closed, for easier installation (fig. 11).
11
20
Zipper
Install the front door panel (20) first. During installation, ensure the zipper
To make sure the strap will stay in the sleeve when assembly
14
12
●
To make sure the strap will stay in the sleeve when assembly
thread the strap through the spindle of the ratchet(fig.12) .
on one side are completely installed and in place.
