2
Installation
The product must be installed and maintained by a suitably
qualified professional in compliance with latest building/
construction and/or electrical regulations and relevant
legislation.
Warning:
Switch off
and isolate the
mains electrical
supply prior to
installing and connecting the luminaire. Do
not open luminaire while mains supply is switched on.
Notice:
If the luminaire is modified by anybody other than
the original manufacturer, then the warranty will no longer
be valid and shall become the full responsibility of the
modifying person/organisation. Claims based on defects
attributable to improper installation and/or application, and
the consequences thereof, are excluded.
In case of component failure, LED replacement due to
abnormal circumstances or at end of life, replacement must
be carried out by a suitably qualified and trained professional.
In case of questions please contact our technical hotline:
+61 458 933 339 (from Monday -Friday from 07.00 until
19.00 hours.
Maintenance
Apart from cleaning the product’s exterior surfaces, no
special maintenance work is required. Do not use high-
pressure cleaners.
Protect our environment: Discard used LEDs in compliance
with the most recent environmental legislation.
Notice:
In case the luminaire is equipped with an optional
available surge protector, the function can get tested if the
signal LED is lit green when the supply voltage is turned on.
In case the surge protector is defective, the LED device
gets automatically disconnected from the mains supply. If
the signal LED is not lit, the luminaire is not functioning.
Installation Procedure
1)
Switch off and isolate the mains electrical
supply.
2)
Loosen screws
A
and remove luminaire
B
.
3)
Install the fixing plate
D
at the assigned position and
firmly tighten cable gland
C
. Use
a fixing
element suitable
for the material of the
installation (
not in scope of supply
).
4)
Place luminaire B on the fixing plate D and firmly
tighten
screws
A.
5)
Ensure
the
supply
is
suitable
for
the
luminaire
type.
Connect
the
flexible
lead
to
the
supply,
the
cable
is
labeled
with
the
connection
data.
6)
The luminaire can
be
adjusted to
an
incli 30°by
loosening of the screw
E
, positioning and re-tightening
.
C
6,5
15
A
B
D
E
C
