WE-EF FLC121, Инструкция по установке и обслуживанию

Страница: 4 / 7

3
Installation
The product must be installed and maintained by a
suitably quali Ƃ ed person in compliance with the latest
applicable regulations and relevant legislation.
Claims based on defects attributable to improper
installation, application, operation and/or any modi-
Ƃ cation carried out by the purchaser or third parties,
and the consequences thereof, are excluded.
Attention: The housing A containing the LED light
source is factory-sealed and does not need to be
opened during installation.
Installation Procedure
Installation – RAIL66 version
Prior to installing the luminaire, mount and connect
the selected RAIL66 mounting system in accordance
with relevant installation instructions
1) Switch off mains electrical supply.
2) Check that rating shown on luminaire label conforms
with mains electrical supply.
3) Determine desired position of luminaire A on rail X ,
dependent on aiming requirements and proximity
to a suitable mains outlet Y .
4) Attach clamp B to rail X . Tighten wingnut C .
5) Remove protective cover Z from mains outlet Y .
Insert in-line connector G and tighten.
Attention: On any mains outlet Y ’ that is not used,
protective cover Z ’ must remain Ƃ rmly secured.
Check and ensure proper Ƃ t and tightness.
6) Loosen screws H and I slightly. Aim luminaire in
desired direction, retighten screws H and I .
Installation – Space frame version
Suitable for space frame diameter 48-60 mm.
1) Switch off mains electrical supply.
2) Determine desired position of luminaire A on space
frame X , dependent on aiming requirements.
3) Attach clamp B to space frame X . Tighten
wingnut C .
4) Detach gear box cover D by loosening screws S .
5) Check that rating shown on luminaire label conforms
with mains electrical supply.
6) Feed mains supply cable E through cable gland G
(Fig. I).
7) Connect mains supply cable E leads to respective
terminals in terminal connector K :
a) ON/OFF (L = Phase, N = Neutral, = Earthing)
b) 1-10 V/DALI (L = Phase, N = Neutral,
= Earthing, DA/DA = DALI control line,
D–/D+ = 1-10 V control line).
8) Reposition gear box cover D and secure in position
by retighten screws S .
9) Loosen screws H and I slightly. Aim luminaire in
desired direction, retighten screws H and I .