wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
2
Step 2:
•
With the help of another person, align the threaded inserts in the (lower)
rail
assembly with the pre-drilled holes in (right)
side panel
.
•
Using a 1/4”-20x1 3/4” joint connector bolt, insert bolt going through the hole in the side panel to the threaded insert. Use a 4mm Allen wrench or
4mm hex bit and a screw gun to fasten the bolt into place. Repeat for the remaining (3) bolts.
•
After the
rail
assembly is attached to the (right)
side panel
, repeat for (left)
side panel
.
•
Repeat this step for the (upper)
rail
assembly.
Side panels
(shown in yellow)
(Right)
(Left)
Rails w/ Armor
Edge (shown in
pink)
(Lower)
(Upper)
NOTE:
Parts shown in grey are assembled in previous steps.
NOTE:
Colored images are for illustrative purposes only.
Red dots show the location
where the joint connector
bolts are to be used in this
step.
