wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
1
Quad XL
Assembly Instructions
Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key) Any parts damaged during shipment must be reported
within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Tools Required
• 4mm Allen
wrench OR
• 4mm Hex bit
• Drill extension
• Phillips drill bit
• Screw gun
• #2 square bit
V062212 Version subject to change
Step 1:
•
Place the longer base cabinet upside down on a
protected flat surface with it’s caster base facing
up.
(Upon installer’s discretion, remove doors and
shelving before turning cabinets over to lessen the
weight of the cabinets.)
Step 2:
•
Align caster with the threaded inserts. (See image to
the right; threaded inserts are marked in red as an
example for assembly instruction ONLY.)
•
Use the 1/4-20x25mm joint connector bolts to attach
casters to the base cabinet.
•
Repeat for remaining casters. (Make sure you have
two locking and two non-locking casters on this
cabinet.)
Step 3:
•
Repeat
Steps 1-2
for the two smaller base cabinets.
Step 4:
•
With someone’s help, position the cabinets right side
up. Make sure to have the all locking casters’ levers
pushed down to secure cabinet in place.
Step 5:
•
Align the pre-drilled holes in cabinet
(B)
with the
threaded inserts in cabinet
(A).
•
With cabinets aligned together, connect them with the
1/4-20x30mm joint connector bolt w/ loc tite going
through cabinet
(B)
. Use a 4mm Allen wrench or 4mm
hex bit and a screw gun to tighten.
•
Use 4 bolts total to connect cabinet
(A)
to cabinet
(B)
.
•
Repeat
Step 5
with the second base cabinet.
Step 5
Steps 1-2
A
B
