1
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
LOBO Tables
Laminate/Phenolic & 1 Pc Butcherblock Tops
Assembly Instructions
Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key on next page) Any parts damaged during
shipment must be reported within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Step 1:
• Place the LOBO top face down on a protected flat
surface.
Step 2:
• Place LOBO frame tabs down on top of the LOBO top and
align with pre-drilled pilot holes.
• If assembling a
Stainless Steel top,
see Stainless Steel
LOBO Table Assembly Instructions.
• If assembling an
Epoxy top,
see Epoxy LOBO Table
Assembly Instructions.
• If assembling a
2 piece Hardwood top,
see Hardwood
LOBO Table Assembly Instructions.
Step 3:
• Starting at one corner, place the 5/16” bolt that is welded
to leg through corner support brace of frame. Repeat for
remaining legs.
Step 4:
• Using a # R2 square bit, secure the leg plate to the top
with #10 x 3/4” square pan screws. Repeat for each leg
plate.
Step 5:
• Place the 5/16” lock washer and 5/16” hex nut onto the leg
bolt and tighten with 1/2” wrench. Repeat on remaining
legs.
• Adjust the leg to desired height.
Step 6:
• Using a # R2 square bit, secure frame to table top with
#10 x 3/4” square pan screws. One screw per tab.
Step 7:
• With someone’s help, turn table upright.
Steps
3
Step
4
V031919 subject to change.
Step
6
Tools Required
• 1/2” wrench
• Screw gun
• # R2 square bit
•
5/16” hex bit
Steps
5
