1
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
V030119 subject to change.
ELO® Desk/Table
Assembly Instructions
Instruc tions are based on the ELO
®
Adapt Desk but c an be used for any ELO® Desk or Table.
Before you begin, please make sure all parts and proper quantities are included. (See Part Identifier Key page) Any parts damaged during shipment must be
reported within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Step
2
Tools Required
• Screw gun
• 4mm Hex bit
• Drill bit extension
• Phillips head screwdriver
Step 1:
• Place top face down on protected flat surface so
threaded inserts are facing up.
Step 2:
• Align leg(see leg options below) with threaded inserts.
• Connect leg to desktop with the 1/4-20x15mm joint
connector bolt. Use six bolts for each leg.
• Use a screw gun, 4mm Hex bit and a drill bit extension to
tighten the joint connector bolts to the desktop.
• Repeat this for the rest of the legs.
Step 3:
• Adjust legs to desired height then flip over.
Step 4:
• If your table requires a support bar/s, align the bar/s with
the pre-drilled pilot holes. Use #8x3/4” screws to fasten
down the support bar to the desktop.
ELO
(-ADJ or -EJA)
1.25” Square Legs
ELR
(-ADJ or EJA)
2” Curved Round Legs
ELS
(-ADJ, EJA or MJA)
2” Straight Round Legs
ELP
(-ADJ or EJA)
2” Straight Round Pin Legs
ELO® Leg Options
#8 Screws
Support bar
Worksurface
(Bottom side)
