2
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
ASSEMBLY
The assembly of this table requires the
assistance of another person.
NOTE: Hardware packs are included in
packaging. You may receive more hardware
than needed. Discard any extra hardware after
assembly.
1. Place
Part ①
with plate facing down on a protected flat surface.
2. Align holes in the end plate of
Part ②
with
Part ①
. Make sure the
tabs
Part ②
are facing down.
Connect cross bar to the frame using
Hardware A
and
Hardware B
.
Use a screw gun and a 4mm hex bit to tighten
Hardware A
and
Hardware B
. We suggest using a 4mm hex wrench to hold the nut
in place while tightening
Hardware A
.
Repeat for other frame leg.
5. Using a screw gun and a # S2 square bit, secure
Part ②
to top with
Hardware D
. Use one screw per tab with a total of (6) screws being
used (3 per side).
6. Before placing
Hardware E
in the bottom of the frame leg, lock the
caster by pushing down on the brake lever.
Twist the stem of
Hardware E
into the hole on the bottom of
Part ①
.
Use 3/4” wrench to tighten 3/4” nut on stem of
Hardware E
.
Repeat for remaining
Hardware E
.
3. Place
Part ③
down on a protected flat surface so threaded inserts
and pre-drilled pilot holes are facing up.
4. Place
Parts ① & ②
on top and align with threaded inserts & pre-
drilled pilot holes.
Using a screw gun and a 4mm hex bit, secure both frame legs to
top with
Hardware C
. Use (8) bolts for each frame leg.
Part ②
Part ③
Part ①
Part ①
Hardware C
Hardware A
Hardware B
Part ②
Part ①
Part ①
Hardware B
NOTE: Product images are for illustrative purposes only
and may differ from actual product.
Part ①
Part ①
Hardware E