Wayne-Dalton 7100 Series Скачать руководство пользователя страница 20

HIGH SPRING TENSION CAN CAUSE 
SERIOUS INJURY OR DEATH.

DO NOT

 adjust, repair or remove springs or parts to 

which springs are connected, such as steel brack-
ets, cables, wood blocks, fasteners or other parts of 
the counterbalance system.

Adjustments or repairs must 

ONLY

 be made by a 

trained door systems technician using proper tools 
and instructions.

DO NOT

 remove, cover or paint over this tag. Prod-

uct user should inspect this tag periodically for 
legibility and should order a replacement tag from 
the door manufacturer, as needed.

©Copyright 2010 Overhead Door Corporation                                                     

102081   REV2 06/24/2010

DO NOT REMOVE, COVER OR PAINT OVER

THIS LABEL. PRODUCT USER SHOULD

INSPECT THIS LABEL PERIODICALLY FOR

LEGIBILITY AND SHOULD ORDER A 

REPLACEMENT FROM THE DOOR

MANUFACTURER AS NEEDED.

346214  NEW 11/19/2010

CALIFORNIA HEALTH AND SAFETY 

CODE SECTION 25249.6

DRILLING, SAWING, SANDING OR 

MACHINING WOOD PRODUCTS GENERATES

WOOD DUST, A SUBSTANCE KNOWN TO THE 

STATE OF CALIFORNIA TO CAUSE CANCER. 

AVOID INHALING WOOD DUST OR USE A 

RESPIRATOR OR OTHER SAFEGUARDS FOR 

PERSONAL PROTECTION.

WARNING

THIS WOOD PRODUCT REQUIRES PROPER    
FINISHING 

PRIOR

 TO ANY DOOR HARDWARE BEING 

APPLIED. BOTH INNER AND OUTER FACES OF THE 
SECTION(S), AS WELL AS ALL EDGE SURFACES 
MUST BE PREPARED AND FINISHED IN STRICT 
ACC0RDANCE TO THE DIRECTIONS GIVEN IN THE 
INSTALLATION INSTRUCTIONS AND OWNER’S 
MANUAL UNDER “MAINTENANCE AND PAINTING 
INSTRUCTIONS FOR ALL WOOD DOORS”.

IMPROPER STORAGE, IMPROPER TRANSPORTATION 
AND/OR DELAY IN FINISHING, THAT ALLOWS FOR 
THE EXPOSURE OF THIS WOOD PRODUCT TO   
MOISTURE AND/OR OTHER CONTAMINANTS, 

VOIDS

 

THE LIMITED WARRANTY.

IMPORTANT

316986

WARNING

WARNING

Lift handles/gripping points are required 

on this door, located as spelled out in the 

installation instructions, even if the door 

is motor operated.
Failure to install and use these lift handles/

gripping points on this door can result in

serious injury to fingers and/or hands, if

placed in the opening between sections,

when the door is operated manually.

The adjacent bottom corner bracket and 
all cable retention features including 
milford pins, cotter pins, & clevis pins are 
under HIGH SPRING TENSION.
Adjustments and repairs must only be

made by a trained door systems

technician, using proper tools and

instructions.

DO NOT REMOVE, COVER OR PAINT OVER

THIS LABEL. PRODUCT USER SHOULD

INSPECT THIS LABEL PERIODICALLY FOR

LEGIBILITY AND SHOULD ORDER A 

REPLACEMENT FROM THE DOOR

MANUFACTURER AS NEEDED.

325304  REV3 06/26/12

© Copyright 2012, 
Overhead Door Corporation

WARNING

WARNING

Lift handles/gripping points are required 

on this door, located as spelled out in the 

installation instructions, even if the door 

is motor operated.
Failure to install and use these lift handles/

gripping points on this door can result in

serious injury to fingers and/or hands, if

placed in the opening between sections,

when the door is operated manually.

The adjacent bottom corner bracket and 
all cable retention features including 
milford pins, cotter pins, & clevis pins are 
under HIGH SPRING TENSION.
Adjustments and repairs must only be

made by a trained door systems

technician, using proper tools and

instructions.

DO NOT REMOVE, COVER OR PAINT OVER

THIS LABEL. PRODUCT USER SHOULD

INSPECT THIS LABEL PERIODICALLY FOR

LEGIBILITY AND SHOULD ORDER A 

REPLACEMENT FROM THE DOOR

MANUFACTURER AS NEEDED.

325304  REV3 06/26/12

© Copyright 2012, 
Overhead Door Corporation

SAFETY INSTRUCTIONS

1.

  Operate door ONLY when it is properly   

 adjusted and free of obstructions.

2.

  If a door becomes hard to operate,  

 

 

inoperative or is damaged,  immediately  

 

have necessary adjustments and/or repairs  

 

made by a trained door system technician  

 

using proper tools and instructions.

3.

  DO NOT stand or walk under a moving door,  

 

or permit anybody to stand or walk under  

 

an electrically operated door.

4.

  DO NOT place fingers or hands into open  

 

section joints when closing a door. Use lift  

 

handles/gripping points when operating  

 door manually.

5.

  DO NOT permit children to operate garage  

 door or door controls.

6.

  Due to constant extreme spring tension,  

 

DO NOT attempt any adjustment, repair or  

 

alteration to any part of the door,  

 

 

especially to springs, spring brackets,    

 

bottom corner brackets, red colored    

 

fasteners, cables or supports. To avoid   

 

possible severe or fatal injury, have any  

 

such work performed by a trained door  

 

system technician using proper tools and  

 

instructions.

7.

  On electrically operated doors, pull down  

 

ropes must be removed and locks must be  

 

removed or made inoperative in the open  

 (unlocked) position.

8.

  Top section of door may need to be    

 

reinforced when attaching an electric    

 

opener. Check door and/or opener  

 

 

manufacturer’s instructions.

9.

  VISUALLY inspect door and hardware    

 

monthly for worn and/or broken parts.   

 

Check to ensure door operates freely.

10.

 Test electric opener’s safety features    

 

monthly, following opener manufacturer’s  

 

instructions.

11.

 NEVER hang tools, bicycles, hoses, clothing  

 

or anything else from horizontal tracks.  

 

Track systems are not intended or designed  

 

to support such extra weight. 

Place label at a readable height on door. DO NOT  

remove, cover or paint over this label. Product 

user should inspect this label periodically for 

legibility and should order a replacement label 
from the door manufacturer as needed.

324100              REV7   09/16/2013

Quality garage doors since 1954

Wayne Dalton

2501 S. State Hwy 121 Bus., Suite 200

Lewisville, TX 75067

For service, call (800) 827-3667

www.Wayne-Dalton.com

Copyright 2013 Wayne Dalton, a

Division of Overhead Door Corp.

 

Residential warning label, The warning label will 

either be on the right or the left end stile.

Bottom section warning labels

Residential Dust label

(For California Residents Only)

Wood label 

important notice

Torsion spring tag(s) 

(one per spring)

20

Содержание 7100 Series























Отзывы: