356914-0004 REVC 04/06/2020
7
©Copyright 2020 Wayne Dalton, a division of Overhead Door Corporation
WINDING DIRECTION
(SOME COMPONENTS NOT
SHOWN FOR CLARITY)
CURTAIN
HEADPLATE
WRAP
GUIDE
CURTAIN
WINDING
NUT
FIG 8A
FIG 8B
HEAD
HOOD
ASSEMBLY
FLANGE
TOP
SCREWS
#10 TEK
WALL
FASTENERS
FIG 11
BOTTOM BAR
STOPPER
CURTAIN
GUIDE
FIG 10A
FIG 10B
Prior to winding or making adjustments to the springs, ensure you Are winding in the proper direction as stated in the Installation Instructions. Otherwise the spring
fittings may release from spring if not wound in the proper direction and could result in severe or fatal injury.
WARNING
WARNING
Winding torsion spring(s) is an extremely dangerous procedure and should be performed only by a trained door system technician using proper tools and instructions.
WARNING
WARNING
Rapidly closing curtain could result in death or serious injury. Use
caution when lowering curtain before spring tension is applied.
WARNING
• Cut the banding and carefully lower the curtain into the guides to
the fully closed position.
• Using a 1-1/2” open end wrench wind the spring by turning the
Winding Nut the specified number of turns indicated on your door
drawing sheet. The winding direction would be the same as the
direction to open the door for both left and right hand drive. See FIG
8A and FIG 8B.
• Check the balance of the door. If needed raise the door and adjust
the number of turns to achieve proper balance.
STEP 3
STEP 3
WIND SPRINGS (SKIP THIS STEP IF YOUR DOOR IS
ELECTRICALLY OPERATED)
• Cut the banding and carefully lower the curtain into the guides to the fully
closed position.
• With door in the closed position attach stopper using stud plate and nuts
provided, as shown in FIG 10A and FIG 10B.
STEP 4
STEP 4
ATTACH BOTTOM BAR STOPPER
• Position the hood in place as shown in FIG 11.
• Align the hood and attach using the #10 tek screws and wall fasteners
provided. See FIG 11.
• If your door is 12’-0” or wider you must also attach the hood to the hood
band, supporting the center of the hood with #10 tek screws provided.
STEP 5
STEP 5
ATTACH FRONT HOOD