PREPARATION
Before beginning installation of product, make sure all parts are present. Compare parts with parts list.
If any part is missing or damaged, do not attempt to install the product.
Estimated Assembly Time: 30-60 minutes
Tools Required for Assembly (not included):
Phillips Screwdriver, Flat-head Screwdriver, Step Ladder, Pliers, Silicone Sealant, Eye Protection.
ASSEMBLY INSTRUCTIONS
CAUTION: PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN!
3
ON
OFF
ON
OFF
OFF
Turn OFF power to work area at main circuit breaker or fuse box.
CAUTION: Do not rely on wall switch to turn off power
Attach crossbar (E) to junction box (not included) with two machine
screws (B).
Ensure that the screw thread on the center hole is pointing away
from the surface.
Remove the protective paper barrier from the adhesive face of the
EVA gasket (F). and adhere the gasket to the crossbar and outer
edge of the round surface junction box.
Ensure that the long machine screw on the crossbar is threading the
hole of EVA gasket.
Wiring the light and junction box through the EVA gasket.
a. Connect the white wire to the white wire by twisting Wire Nut (D).
b. Connect the black wire to the black wire by twisting Wire Nut (D).
c. Connect the green/yellow wire of light to the ground wire from
junction box by using ground screw (A, painted green) onto the
crossbar.
Make sure wire connections are secure.
Carefully place wires into junction box.
Position wall plate over the crossbar (E).
Mounting the light onto the crossbar and secure with the NUTS (C)
DO NOT over tighten.
For wet location, make sure fill full the gap of EVA gasket and
mounting surface with sealing compound or silicon glue.
1.
2.
3.
4.
Once all connections are complete and the silicone is
dry you can turn on the power to the light at the main
junction box or breaker panel.
Black
White
MOUNTING CROSSBAR
WIRING THE LIGHT
MOUNTING THE LIGHT
B
B
F
D
C
A
E
B1
