Waygate Technologies Krautkramer USM 100, Руководство по эксплуатации, Страница: 251 / 330

Data Recorder 6 Documentation
Krautkrämer USM 100 Rev. 9 (09/2023) 251
Storing readings
Following the creation of the data recorder file (see
page 245), you can store readings the individual cells.
Note
During the recording process the settings are
not changeable. To change the data matrix
you must first stop the recording. Then you
can create a new data recorder file.
All recorded data is immediately stored in the data re-
corder file. You can pause and resume recording at any
time.
If you delete the recorded data, a new data recorder file
will be created automatically. When deleting, no data is
lost, because it is already stored in the data recorder file.
– Couple the probe to the first measuring point. The
reading can be displayed in the Measurement line
(see page 120).
– In the Command bar tap the Record icon (see
page 76). The reading is stored and visible in the first
cell. After storing, the next cell is automatically select-
ed.
– Store more measurements in the same way.
– Tap the Pause icon (see page 76) to interrupt the re-
cording of measurements. The data recorder file re-
mains open.
– Tap the Resume icon (see page 76) to continue stor-
ing measurements.
– Tap the Clear icon (see page 75) to finish the record-
ing of measurements.
– Confirm the security prompt that appears.
The data recorder file is closed and you can start a new
file.