Waygate Technologies Krautkramer USM 100, Руководство по эксплуатации, Страница: 217 / 330

Verifying the encoder 5 Operation
Krautkrämer USM 100 Rev. 9 (09/2023) 217
5.28 Verifying the encoder
Once all parameters of the scanner system are set (see
from page 213), you can start the verification.
– Mark the reference distance for verification according
to the settings in Expected Dist. X and Expected
Dist. Y (see page 215).
– Move the probe to the starting position on the X-axis
and the Y-axis.
– In the Command bar tap on Calibrate (see page 74)
to start the procedure.
– Follow the instructions on the screen.
Once the verification is completed, the encoder resolu-
tion settings are updated.
Note
When using the Phoenix Inspection System
tracer encoder, no verification is required.
Set the resolution of the encoder to 5 ticks/
mm as described in the encoder manual.
Then the device can detect the correct posi-
tion of the probe..