D mode CT User Guide
4
Copyright © 2005 Waxess
Install the batteries
(Optional)
The optional back-up batteries provide a reserve power supply so
the base can operate for up to 30 minutes (depending on battery
condition) in case of power outages or if power is cut off to the
base for any reason. Backup power activates immediately when
the normal power supply to the base is cut off.
1
Verify power is disconnected from the base.
2
Open the battery cover on the bottom of the base.
3
Insert five AA alkaline batteries
with the polarity (+ and -)
aligned as marked in the
compartment.
4
Replace the cover.
• Batteries are not included and
must be purchased separately
• Batteries are not required to
operate the product
Note:
There is no indication that
shows when the base is operating with normal power or
back-up power. If you choose to install back-up batteries,
check the power level frequently (see “Power back-up” on
page 33). Replace the batteries when the power level is
less than half of maximum. After any power outage, check
the battery power level and replace batteries as needed.
Standby Screen
When the sequence is complete, the
Standby Screen appears. This screen
appears on both the base and the
handset, and is always visible when the
D mode CT user guide final.book Page 4 Tuesday, May 24, 2005 6:57 PM