SmartSensor HD
QUICK-REFERENCE GUIDE
www.wavetronix.com
801.734.7200
2
Select a mounting height
1
Ensure that all necessary components are available
You will need a number of items in order to install your sensor, including but not limited to the items below:
Use the table to select the mount-
ing height for the sensor based on
the offset from the nearest detec-
tion lane. The range of ideal offsets
is highlighted in gray. If possible,
use the height contained in the
second column (Recommended
Mounting Height).
In areas with a lot of truck traffic,
consider a higher mounting height
to help mitigate occlusion.
Note.
This table is truncated. For
a complete table, refer to the HD
user guide.
Offset from first
Detection Lane
(ft/
m
)
Recommended
Mounting Height
(ft/
m
)
Minimum
Mounting Height
(ft/
m
)
Maximum
Mounting Height
(ft/
m
)
6
/ 1.8
12
/ 3.7
9
/ 2.7
19*
/ 5.8*
10
/ 3
12
/ 3.7
9
/ 2.7
22
/ 6.7
15
/ 4.6
15
/ 4.6
12
/ 3.7
26
/ 7.9
20
/ 6
18
/ 5.5
15
/ 4.6
30
/ 9.1
25
/ 7.6
26
/ 7.9
17
/ 5.2
33
/ 10
30
/ 9.1
29
/ 8.8
19
/ 5.8
37
/ 11.2
35
/ 10.7
30
/ 9.1
20
/ 6
40
/ 12.2
40
/ 12.2
33
/ 10
22
/ 6.7
43
/ 13.1
45
/ 13.7
36
/ 11
23
/ 7
40
/ 14
50
/ 15.2
39
/ 11.9
25
/ 7.6
50
/ 15.2
*Reduction in number of reported speeds
˽
Mount bracket and Band-It clamping system
˽
Sensor cable and homerun cable
˽
Click equipment and pole-mount box
˽
Laptop with SmartSensor Manager HD, down-
loaded from wavetronix.com
˽
Bucket truck
1
Attach the mount bracket to the pole using the straps.
2
Tighten the strap screws partway. The sensor alignment will need to
be fine-tuned later, so keep the straps slightly loose.
3
Attach the sensor to the bracket; the connector at the bottom of the
unit should point towards the ground.
4
Place the lock washers onto the bolts, thread on the nuts and tighten.
3
Attach the sensor and mount bracket to the pole
