Waveshare XNUCLEO-F030R8, Руководство пользователя

Страница: 20 / 22

Xnucleo User Manual
20
V2.6.1, Apr. 25
th
2015
share awesome hardware
0.96inch OLED
DIN PA7/D11 PA7/D11 PB15/D11 PA7/D11 PA7/D11
CLK PA5/D13 PA5/D13 PB13/D13 PA5/D13 PA5/D13
CS PB8/A5 PB8/A5 PB8/A5 PB8/A5 PB8/A5
D/C PB9/A4 PB9/A4 PB9/A4 PB9/A4 PB9/A4
RES PB0/A3 PB0/A3 PB0/A3 PB0/A3 PB0/A3
Notices:

The pins VCC and GND of the sensors listed above should be connected to the pins VCC and
GND of IO Expansion Shied. For more detailed information, please refer to IO Expansion
Shied User Manual.

Some of the sensors may only lead out the pin AOUT or the pin DOUT. In this case, the
additional reserved pin(s) of IO Expansion Shied can be left unconnected. One IO Expansion
Shied can only connect one sensor at a time.
4.2 DEMO EXPLANATIONS
When the Demo is running, the LED1 on the XNUCLEO board will blink at the rate of every 2
seconds.
4.2.1 DATA DISPLAY MODE
For the periphery module Demo, there are two modes for displaying the returned information
from the module: OLED and Screen Print (relative information is sent to the PC via the serial port
every 500 ms). Here is an example:
Figure 7: OLED displays relative sensor parameters