Waves HPSA-7100-R Series, Инструкция по установке и эксплуатации

Страница: 46 / 179

Installing the Speaker Array
20 HPSA-7100-R Series Installation and User Manual
P/N P01- 04946 Rev C
9. Connect a 1/4” female spade crimp connector to one end of the cable.
10. Connect the cable to the Driver’s connection point.
11. Mount the driver cover to the driver assembly using the Phillips screws included
with the cover.
FIGURE 3.4 Attach the Horn Driver Cover
12. Repeat steps 3
–10
for all horns.
13. Refer to the site design to determine which speaker configuration to use: omni-
directional (360°) (facing opposite directions) or uni-directional (180°) (facing the
same direction).
FIGURE 3.5 Correct Positioning of Multiple Uni and Omni Directional Speaker Pairs
It is necessary to ensure the polarity of all drivers are identical. The driver is
marked as Terminal 1 and Terminal 2. Terminal 1 must be connected to Horn
# positive (+).
Attach driver cover
to driver assembly
on horn.