Axis One / User Guide
8
Setting up eMotion LV1
All devices should be properly connected and powered on. Software, plugins, and licensees should be
installed.
Launch LV1 and open the Setup window. Go to the System Inventory page.
Start Auto-Configure. This function locates the Axis One Ethernet port that’s connected to the SoundGrid
network, discovers and assigns devices, and patches audio. If Auto-Configure cannot locate the correct port,
use the Port drop-down menu to assign it manually. Then re-run Auto-Configure.
When Auto-Configure is complete, there’s a good chance that one or more of the I/O devices or servers will
need a firmware update. This is indicated by a blue FW button on the device icon. Click the button to start.
Follow the prompt and restart the I/O device when the update is finished.
1
The I/O devices and server(s) should now be up and running in the Device Racks. You’re now ready to patch
audio and start mixing.
Please refer to the
eMotion LV1 user guide
for comprehensive instructions about setting up and using the
mixer.
1
For the SoundGrid network to operate properly, device firmware must be up to date with the eMotion LV1 application software that’s currently
running. If these are not in sync, you will be prompted to update the firmware.
Specifications
Electrical
110/220v, 60
Hz or 50 Hz, auto-
switching
Typical power consumption:
@120 VAC: 37 watts (+/-20 watts), 0.37
A
@220 VAC: 35 watts (+/-20 watts), 0.27
A
Dimensions
Width: 22 cm/ 8.66 in
Length
(front to back): 25.2 cm
/ 9.9 in
with rear
connector
: 25.6 cm
/
10.7 in
Height: 8.6 cm
/ 3.39 in
Software Enclosed
Windows 10
Waves V10 software
Waves Central application