¯
2004 Wave Frontier Co
T55
ൡ
TIP
If possible, align Toroidal on the ground level with your receiver and monitor right next
to Toroidal. (or use a sat finder equipment). It is MUCH FASTER, EASIER and SAFER.
ൡ
AZIMUTH SETTING
1. Connect your receiver to the center LNBF
(closest one to the center). Do not use
any switch at this point unless you are
absolutely certain that your switch and
receiver works properly.
2. Swing the dish left/right to find signal on
your center LNBF. You may also need to
adjust elevation to do this.
3. Once you found signal, do the fine-tuning
by adjusting elevation and azimuth and
check signal strength simultaneously, get
the best possible signal you can get.
4. You will need to move the dish (up/down
and left/right) a little by little to get the
best signal. It will take your time and
patience.
ൡ
LNBF LOCATION ADJUSTMENT
Once you have a satisfactory signal on the
center LNBF, move on to the next LNBF.
You can also make adjustment on location of
each LNBF (except center-LNBF) to get a
better signal.
Tip: Even if your azimuth is off from the
calculated setup info, you can recover azimuth
offset by adjusting LNBF location on the guide.
ALIGNMENT: TOROIDAL
