Baseband Design
confidential ©
Page :
36 / 58
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
WM_PRJ_Q24NG_PTS_002-001 June
2006
Recommended characteristics for the speaker:
•
Type: 10 mW, electro-magnetic.
•
Impedance: 32 to 150
Ω
.
•
Sensitivity: 110 dB SPL min. (0 dB = 20 µPa).
•
Frequency response compatible with the GSM specifications.
3.3.2.3 Buzzer
Output
The buzzer output (BUZZER) is a digital output. A buzzer can be directly
connected between this output and VBATT. The maximum current is 100
mA (PEAK).
A diode against transient peak voltage must be connected as described
below.
Typical implementation:
C1
D1
VBATT
BUZ
R1
Figure 18: Example of Buzzer implementation
R1 must be chosen in order to limit the current at I
PEAK
max (recommended
values 10
Ω
to 50
Ω
).
C1 = 0 to 100 nF (depending on the buzzer type).
Recommended characteristics for the buzzer:
•
Type: electro-magnetic.
•
Impedance: 7 to 30
Ω
.
•
Sensitivity: 90 dB SPL min @ 10 cm.
3.3.2.4 Routing
constraints
To get better acoustic performances, basic recommendations are the
following:
•
The SPKxx lines must be routed in parallel, without any wire in
between.
•
The MICxx lines must be routed in parallel, without any wire in
between.
•
All the filtering components (RLC) must be placed as close as
possible to the associated MICxx and SPKxx pins.
