13. Now pull up the sides of the
inner liner, so that the black top
rim sits neatly on top of the foam
wall, and the zip ends are aligned
as closely as possible to avoid
stress on the zip.
14. Connect the zipper (starting
above the heater) and slowly work
around the spa to zip the outer and
inner liners together.
15. Inside the spa, y
ou can find the
Water Circulation Outlet (A)
Filter Connector (B)
Drainage Plug (C).
16. Screw the Filter Cartridge onto
the Filter Connector (B), turning
clockwise until hand tight.
17. Add the Filter Protector Cover
onto the Filter Cartridge.
18. Smooth out any creases or
loose material in the bottom of the
spa, to avoid trapping air under the
floor when filling.
10. The heater can now be stood
upright and fitted snugly into the
cut-out in the foam panel. Take
care to ensure the heater controller
cable does not get caught.
11. [GARDA only] The support
frame should sit neatly into the
grooves in the heater casing.
12. The outer liner can be pulled
up to fully cover the foam walls,
ensuring the foam is neatly
positioned to give the best
possible fit.
(C)
(B)
(A)
