EN
15
16
5. MAINTENANCE
5. MAINTENANCE
5.1. Water maintenance
WARNING: Bad spa water quality can harm your health.
5.2. Cleaning and replacing the filter cartridge
5.2a Disinfection
1
2
3
5.3. Drainage and storage
Drainage
4
Storage
5
5.4. Repair kit
6
5
7
8
1
2
3
6
7
8
Depending on the frequency and conditions of use:
- The filter cartridge should be regularly cleaned / replaced every 150 hours max.
- The filter cartridge should be replaced every 150 hours unless cleanable.
- The spa water should be changed every 15 to 30 days.
Use a water tesy kit to control the parameters of the water before using the spa, or at least once a
week.
Use disinfection products fo the spa. The treatment products should be used with caution and it is
imperative to refer to their instructions.
Damage resulting from improper use of treatment products is not covered by the warranty.
1. Water balance
The water balance (pH) must be maintained between 7 and 7.4.
2. Water Sanitation
To sanitise the spa water, we suggest using an active oxygen-based treatment or
bromine placed in a floating dispenser. (Dispenser sold separately).
A dirty filter cartridge may contaminate the spa water and cause damage tp the heating function.
1. Unscrew the filter case by turning it anti-clockwise. Take oiut the filter cartidge from the case.
2. Rinse off the filter cartridge with a garden hose. If the filter cartridge remains dirty and
discoloured, the
filter cartridge should be replaced.
3. Put back the cleaned filter cartridge into its case and screw it to the spa.
Water Sanitation:
To sanitise the spa water, we suggest using an active oxygen-based treatment or bromine placed
in a floating dispenser. (Dispenser sold separately).
Seek professional advice and guidance before doing this.
Attention:
Detergent residues and dissolved solids from bathing suits and chemicals may build up on the spa
walls. Use sopa and water to clean the walls and rinse thoroughly with a garden hose using a
direct water spray.
Check the stopper on the bottom of the spa and the drain cap.
Unscrew the drain cap.
Remove the stopper on the bottom of the spa. Completely drain all water from the spa.
Once empty, the spa can be cleaned with soap and water.
Press the bubbling button to blow out the water inside the jet holes. Unplug the pump,
remove the filter cartridge from the inner wall of the spa.
Use a towel to wipe off the spa, dry for 24 hours.
Unscrew the valves to deflate the spa.
Fold the spa.
It is recommended to store the spa in its original package in a warm dry place.
Little holes or punctures can be repairs with the repair kit included and glue can be adhered to
the spa liner.
1. Find the leak.
2. Thoroughly clean the area surrounding the leak.
3. Cut a piece of repair material in a round shape, which should be largers than the damaged
area.
4. Apply adhesive to the back of the patch and around the area to be repaired.
5. Put the oatch on the damaged area and press down firmly. Allow 12 hours for repair to dry.
After the patch has dried, apply glue around the edges for a complete seal (dry 4 hours).
Ensure NO bubbles are left under the patch.
C
M
Y
CM
MY
CY
CMY
K
Wave_Installation and user manual_SWIFT US_OUTLINED AND EMBEDDED.pdf 8 10/09/2021 12:05:03