WATTWHEELS LTD
12
BATTERY & CHARGING
The battery can be either charged by leaving the battery in the bike or by removing it. To charge while in the battery open the rubber cap located on
the right-hand side of the downtube and plug the charging pin into the slot.
To remove the battery, turn the wheel slightly so you have better access to battery. Turn the key to the unlock position and then turn the lever on the
battery case to release the battery
Removing the battery from the bike when storing it for a long period of time is recommended. In this case store it in a cool, dry area away from water.
The charge left in the battery should be 50%-75% for long storage times.
Cleaning the battery and battery housing should only be done while disconnected and powered off. Use a dry rag or if needed a lightly damp rag.
DO NOT
spray with high-pressured water to prevent damage or possible short-circuiting. Only charge the battery with the supplied charger as others may not
function properly, and this increases the possibility of fire or explosion.
Do not store the charger or battery in a wet/damp place or in direct sunlight.
Lithium-ion batteries can last longer if you recharge with 10-15% of the charge remaining to prevent damage to the cells. Keep both the battery and charger
out of the reach of children and If there appears to be an issue with the charger or battery, stop use immediately and contact either the manufacturer or
Wattwheels at [email protected]
