wattsonic 4.0K-25A-3P, Руководство пользователя

Страница: 37 / 121

37
ISub-Master BMS + 4 Battery Modules
Suggested
Wall Mounted (vhorizontal)
1) Use the back sheet as the template to
mark the position of holes on the wall.
Make sure the back sheet is in a horizontal
position.
2) Use an electrical driller to drill holes
on the wall and make sure hole depth is
enough.
3) Insert the expansion tubes into the holes
and tighten them, then fix the bracket onto
the wall with expansion screws by using a
cross screwdriver.
Mounting the inverter
Lift up the inverter with both hands, hang
the back rail on the back sheet carefully.
Mounting the cables cover
After all the cables are connected (you can
refer to cables connection instruction in
this manual for more details), push into the
cables cover from the right side.
Warning: Before drilling, make sure to avoid the buried water tube and electric wires
in the wall to avoid danger.
Back sheet positioning and installation
Mounting the Sub-master BMS and
battery modules
Lift up the Sub-Master BMS or battery
modules with both hands, hang the back
rail on the back sheet carefully.
Start the installation from the bottom one,
complete the installation from bottom to
top.
Please use 4pcs battery
back sheet expansion
screws to fix the Sub-
Master BMS and battery
back sheet to wall.
Please use 7pcs Inverter
back sheet expansion
s c r e w s t o f i x t h e
Inverter’s back sheet to
wall.
Cables Connection
Please refer to Page34 for Sub-Master
BMS and batteries cables connection
and Sub-Master BMS and inverter cables
connection.
Total height
1595mm
minimum 150mm
to the ground
minimum 540mm