Watts ZRO-4, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 19

8
Blue Tube Connection (From The RO Module To TANK)
Position tank in desired location. Stand it upright or lay it on
its side (using the black plastic stand). Measure the blue tube
(marked “TANK”) from the RO module to the tank and cut it to
length leaving a straight, square edge. Insert the tube into the
quick connect fitting on the tank ball valve. Make sure the tube
is pushed in all the way to the tube stop.
Step 17
Note: Set the blue ball valve knob in-line with the blue tube, this is the “open” position.
Start up Instructions
Step 1 Turn on the incoming hot and cold water angle stop valves.
Turn on the water adapt-a-valves.
Check the system for leaks and tighten fittings as
necessary.
Note: Check daily over the next week to ensure no leaks are present.
Step 2 Plug the (24 volt) transformer power cord connector into the RO
system wire harness connector (labeled transformer.)
Step 3 Plug the transformer into the electrical outlet under the sink.
Step 4 Ensure ball valve on tank is open.
Step 5 Open the RO faucet and leave it open until water begins to drip. Then close the faucet.
The tank will take approximately 4 hours to fill.
Note: If no water comes out of the RO faucet after a few minutes check the power
outlet. It is possible that the power outlet you used for the RO unit is controlled
by the garbage disposal switch. To test - Unplug the garbage disposal and flip
the garbage disposal switch to “on” . If the RO pump turns on and water starts to
drip out of the RO faucet you will need to connect the system to a different power
outlet socket.
Note: Water may be cloudy or milky due to air in the system and carbon particles flushing out
of the final polishing filter. This condition will resolve itself after flushing a couple of
tanks of water.
Step 6
This flushing procedure is only necessary after the initial installation and after
replacing the RO membrane.
Warning: To prevent the possibility of electrical shock, clean up any water on
cabinet floor and dry all water from outside of RO unit.
After the Tank has filled, open the RO Faucet to flush the tank completely. You will know
that the tank is empty when the flow rate from the RO faucet is down to a trickle. Repeat
this step two more times. The fourth tank can be used for drinking. This process should
take approximately 24 hours to complete.