WATT AGE PT-19 CORNELL EP ARF, Инструкции по окончательной сборке

Страница: 10 / 32

10
❑
After the C/A has fully cured, set the wing into the wing saddle and
secure it into place, using the M3 x 20mm flange-head self-tapping screw.
☞
Don't overtighten the screw or you'll crush the wing. It only needs
to be tightened snugly.
STEP 2: ALIGNING THE HORIZONTAL STABILIZER
✦ ✦
✦ ✦ ✦
IMPORTANT
✦ ✦
✦ ✦ ✦
Although not installed yet, keep in mind that the elevator joiner wire MUST be installed in the stabilizer mounting
slot BEFORE gluing the stabilizer in place.
❑
Remove the two elevator halves from the horizontal stabilizer and set them aside for now. Again, you can throw away the
temporary plastic tabs that are in the hinge slots.
✦ ✦
✦ ✦ ✦
IMPORTANT
✦ ✦
✦ ✦ ✦
Don't skip ahead and hinge the elevator halves before installing the stabilizer. If you hinge the elevator halves
now, it will be impossible to install the stabilizer.
❑
Kwik Bond Thin C/A
❑
Kwik Bond 5 Minute Epoxy
❑
# 2 Phillips Head Screwdriver
❑
Excel Modeling Knife
❑
Ernst Airplane Stand
❑
Ruler
❑
Pencil
❑
(1) Fuselage
❑
(1) Horizontal Stabilizer w/Elevator Halves
❑
(1) Vertical Stabilizer w/Rudder
❑
(1) Prebent Elevator Joiner Wire
❑
(1) M3 x 20mm Flange-Head Self-Tapping Screw
❑
Builder's Triangle
❑
220 Grit Sandpaper w/Sanding Block
❑
Masking Tape
❑
Paper Towels
❑
Rubbing Alcohol
❑
NHP Epoxy Mixing Sticks
❑
NHP Epoxy Mixing Cups
YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
SECTION 8: STABILIZER INSTALLATION
STEP 1: INSTALLING THE WING
❑
Carefully apply a couple of drops of thin C/A into the predrilled
threaded wing hold-down hole in the fuselage.
☞
The C/A will harden the threads in the plywood, preventing them
from stripping out over time.
Continued On Next Page
☛ ☛ ☛ ☛ ☛
✦ ✦ ✦ ✦ ✦
WARNING
✦ ✦ ✦ ✦ ✦
Allow the C/A to dry completely before proceeding or you may inadvertently glue the wing hold-down screw into
the fuselage.