Tonic Inno Table
Assembly Instructions
Pg. 1 of 2 INS-TNC TWTRC
26246 Twelve Trees Lane NW, Poulsbo, WA 98370 | 800.426.1202 | www.watsonfurniture.com
Tools Required
Cordless drill, magnetic insert-bit holder,
8” or longer driver extension, #2 insert or Pozidriv bit
Step 1
– Position top components
Place the rotating top assembly (A) top-side down on a flat floor. Place the outer table top ring (B), top-side down, over the
rotating top assembly. Rotate the sub top so that the groups of 5 pilot holes are roughly aligned with the groups of 3 pilot
holes in the outer table top ring.
NOTE: Be sure the floor is cleaned of any debris that might scratch the table top surfaces.
Figure 1
ITEM NO.
COMPONENT
QTY
A
ROTATING TOP ASSEMBLY
1
B
OUTER TABLE TOP RING
1
C
LEG
4
D
#10 x 1” CROSS DRIVE, PAN HEAD SCREWS
32
A
B
