Watson Marlow Pumps 530 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 94 / 127

PIN entry on start-up
The setting PIN entry during start-up can be used to configure the software to choose if PIN entry is
required during start up.
This feature also means that auto-restart capability is now independent of PIN code entry after start up.
If this setting is enabled
ü
then the pump will require the PIN code to be entered before the pump will
enter the home control screen after a power cycle.
If this setting is disabled
û
then the pump will not require the PIN code to be entered before the pump
will enter the home control screen after a power cycle.
The auto-restart response of the pump after a power cycle is now independent of PIN entry.
The default setting, is enabled
ü
so a PIN code will be required after a power cycle before the pump will
enter the home control screen.
Disabling this feature does not change any other aspects of PIN code operation. Anyone wishing to
modify pump settings will still need to enter the PIN code.
21.2 General settings
To view the general settings menu, select GENERAL SETTINGS from the main menu.
Auto restart
This pump includes a feature called auto restart. This setting only applies to pump operation in manual
mode.
If the pump is operating in manual mode and this feature is enabled (configured to 'yes'), it will change
the way the pump responds to a power cycle.
When Auto restart is enabled it will cause the pump to remember it's current operating settings when
power is lost and to resume using these as soon as power comes back on.
The '!' symbol is also displayed when the auto restart feature is enabled to warn users that the pump has
been configured in a way that could result in unexpected operation.
Press ENABLE / DISABLE to turn the auto restart feature on/off (Manual mode).
94 m-530en-en-01