PM3/PM6 LEGACY™ Express PID Controller • 26 •
Setup Menu
SET UP MENU
(Continued)
To enter the Setup Menu, push and hold the
up and down arrow keys for approximately
3 seconds. Once there, push the green
advance key to scroll through to the prompt
of choice and then use the up and down
arrow keys to change the range.
Setup Menu
‰
[`loC]
Lockout Menu
[`SEn]
Sensor Type
[`Lin]
Linearization
[`deC]
Decimal
[`C_F]
Display Units
[`r;lo]
Range Low
[`r;hi]
Range High
[`fn1]
Function Output 1
[`o;ty]
Output Type
[`fn2]
Function Output 2
[`h;ag]
Heat Algorithm
[`h;sC]
Hysteresis (Heat & Cool)
[`C;Ag]
Cool Algorithm
[`A;ty]
Alarm Type
[`A;hy]
Alarm Hysteresis
[`A;lg]
Alarm Logic
[`A;lA]
Alarm Latching
[`A;bl]
Alarm Blocking
[`A;si]
Alarm Silencing
[A;dsp]
Alarm Display
[``rp]
Ramp Action
[`r;rt]
Ramp Rate
[`s;lo]
Scale Low
[`s;hi]
Scale High
[o;hi1]
Power Scale High Output 1
[o;hi2]
Power Scale High Output 2
[`Ad;s]
Zone Address
[btth]
Bluetooth
Setup Menu (cont.)
Display
Parameter Name Description
[`s;hi]
[ S.hi]
Scale High Output 1
Set the scale high for process output in electrical
units. This value; in volts or mil liamps, will correspond
to 100% PID power output.
Appears if: Output 1 is a Process set to heat or cool
Range (Defaults are shown in bold)
-100.0 to 100.0,
10.0
[o;hi1]
[o.hi1]
Power Scale High Output 1
Set maximum value of output 1 range.
Appears if: Output 1 is Switched and set to heat
or cool
Range (Defaults are shown in bold)
0.0 to 100%,
100.0
[o;hi2]
[o.hi2]
Power Scale High Output 2
Set maximum value of output 2 range.
Appears if: Output 2 is Switched and set to heat
or cool
Range (Defaults are shown in bold)
0.0 to 100%
100.0
[PAr1]
[PAr1]
Upper or Left Display
Select parameter to display.
Appears if: Always
Range (Defaults are shown in bold)
[AC;pU
Active Process Value,
[`A;hi]
Alarm High Set Point
[`A;Lo]
Alarm Low Set Point,
[none]
None
[PAr2]
[PAr2]
Lower or Right Display
Select parameter to display.
Appears if: Always
Range (Defaults are shown in bold)
[AC;SP]
Active Set Point,
[`A;hi]
Alarm High Set
Point
`A;Lo]
Alarm Low Set Point,
[none]
None
[`ad;s]
[ Ad.S]
Zone Address - Standard Bus
Communication
Set zone address from 1-16.
Appears if: Always
Range (Defaults are shown in bold) 1-16,
1
[btth]
[btth]
Bluetooth
Sets the power to the Bluetooth® module to on or
off. Appears if: Always. Range (Defaults are shown
bold)
On,
Off The Bluetooth radio can only be
turned on via the front panel once turned off.
