A p p l i c a t i o n 6
Wa t l o w M
I N I
C
H E F
2 0 0 0
■
6 3
•
The heat output indicator light - G, just below the display- will light up whenever
the controller is calling for heat.
When the oven is at operating temperature (above the relative set point minus the
ready band)
[ready]
will appear on the display and the Start/Stop key indicator
light will flash rapidly. You are now ready to cook with the active menu.
If the oven is at operating temperature, the display goes directly to
[ready]
with-
out indicating preheat or temperature.
Note: You can skip preheat and go directly to the cooking sequence by pressing the Start/Stop key a second time.
Run a Menu (with preheat feature)
This procedure describes how to run an active menu when the preheat feature is active
(when the
[ready]
parameter in the
[setUp]
function of the Configuration mode is set
to
[``yes]
).
1.
Set the menu as shown earlier.
2.
With
[`idle]
or time of day on the display, press the Start/Stop key.
If the preheat condition has not been met, the oven will preheat until
[ready]
appears on the display.
Note: You can skip preheat and go directly to the cooking sequence by pressing the Start/Stop key a second time.
If the oven is already at operating temperature
[ready]
will appear on the display.
3.
With
[ready]
on the display, place the food in the oven Then press the Start/Stop
key (indicated by the rapidly flashing indicator light).
The Start/Stop key indicator will light up. Time will count down on the display.
Depending on the way the controller was programmed at
[Etype]
/
[Steps]
the
menu will run in one step or two.
One Step
Countdown time is displayed.
Set point 1 will run until time expires.
Two Step
Countdown time is displayed. It is the total of the programmed Time 1 plus Time 2.
Set point 1 will run until Time 1 expires.
Set point 2 will run until Time 2 expires. You will not see the switch-over from Time
1 to Time 2.
4.
When the cooking sequence is complete,the unit will switch to the Hold sequence.
An audible tone will sound for two seconds.
The display will alternate slowly between
[`HoLd]
and count up time.
A
B
D
E
C
F
G
H
M
INI
C
HEF
2000
[`idle]
Edit
Accept
Back-Up
Exit
SLOW
FLASH
AT OPERATING TEMPERATURE
(PREHEAT CONDITION MET)
RAPID
FLASH
B
D
E
C
F
M
INI
C
HEF
2000
[100f`]
Edit
Accept
Back-Up
Exit
B
D
E
C
F
M
INI
C
HEF
2000
[ready]
Edit
Accept
Back-Up
Exit
G
H
G
H
A
A
[pre-`] [`Heat]
Содержание MINICHEF 2000
Страница 24: ...22 Watlow MINICHEF 2000 Application 2...