10. Slide boiler into chassis compartment and press firmly to ensure boiler
is properly placed (fig. E). To prevent personal injury or property
damage, the boiler must be fully engaged prior to start-up.
11. Plug power cord into a properly rated, grounded outlet.
12. Press “Start” button at base of boiler (fig. E). “Start” button will illum-
inate when heating; however, the light will go out and boiler will stop
heating if electrical power is interrupted or stopped. If this occurs,
press “Start” button again to restart the distillation cycle.
NOTE:
The cooling fan will not start immediately because of a
delayed fan start-up feature. The fan will start once the boiler has
reached a predetermined temperature, approximately 30 to 40 minutes
after starting the cycle.
WARNING:
To prevent personal injury, burn and/or scald injury,
DO NOT
remove boiler while “Start” button is illuminated or at any time
when the boiler is hot. Always unplug Distiller from wall outlet and allow
boiler to cool completely before removing it from the Distiller (at least 30
minutes).
DO NOT
change
position or location of Dis-
tiller while it is operating or
cooling.
13. Place prepared carbon
filter cup into opening
at the top of the collec-
tor/dispenser bottle.
DO NOT
install cap
onto bottle (fig. F).
14. Replace the collector/
dispenser bottle
(fig. F). Make sure the
dispensing valve is
securely tightened.
Waterwise 9000 Distiller Use & Care Guide
7
Figure
E
Start
Button
Boiler
Boiler
Boiler Cap
Spout
Maximum Fill Point
(bottom of tabs)
Steam Baffle Securing Nut
Steam Baffle (flat side)
O-ring
Flange
Gasket
Figure
D
Boiler Cap
Gasket
Distiller
Chassis
