NOTE:
Waterway does not assume responsibility for software changes by other pump
manufacturers.
Section 3. Install Controller Box
When mounting the controller box in the equipment pad, instructions
must be followed exactly. Read through the Important Safety
Information section completely before beginning installation and
before operating the equipment.
Before you begin installation, make sure you have the necessary tools
and a suitable location to install the OASIS.
NOTE:
The controller should be located at or near the equipment pad.
Locate the controller at least five (5) feet or more away from pool/spa
and five (5) feet off the ground. All national, state, and local codes are
applicable.
NOTE:
For Canadian installations, the controller must be at
least three (3) meters (9.8 feet) away from the pool/spa.
3.1
Mount the Controller Enclosure
1. Using a flat screwdriver, rotate door latch to unlock the front
cover of the controller.
2. Open the front cover door and remove the mounting
hardware kit.
3. Using the holes in the bracket as a guide, mark four (4) dots
on the surface where the controller will be mounted. The
four (4) mounting holes are 3-15/16” (10 cm) apart center
to center.
NOTE:
Make sure to mark out the four (4) holes as accurately
as possible.
4. Drill four (4) holes in the mounting surface.
5. Press the four (4) plastic anchors firmly into holes.
6. Screw the mounting bracket onto the mounting surface with
the four (4) screws provided.
continued next page
5
2.3
Materials and Tools
Package contents will vary depending on which OASIS configuration you are installing.
Installation Materials Furnished
• Screw Set (includes Plastic Anchors)
• Metal Mounting Bracket
Tools Needed for Installation
• Power Drill
• 3/16” Drill Bit - Hammer Drill Bit (only necessary to drill into brick or concrete)
• Conduit Fittings
• Wire Nuts
• Wire Crimping Pliers
• Pencil or Marking Pen
• Flat Head Screwdriver
• Phillips Head Screwdriver
• Small Flathead or Slotted Screwdriver
WARNING
FOR YOUR SAFETY:
This product must be serviced by a
professional pool/spa service technician as described on the front
cover of this manual. The procedures in this manual must be
followed exactly. Failure to follow warning notices and instructions
may result in property damage, serious injury, or death. Improper
installation and/or operation will void the warranty.
