INSTALLATION INSTRUCTIONS
3c. If the pool or spa surface has no usable holes around the suction pipe
that will hold the support plate securely, drill two new 0.160" diameter
holes in the plastic ring. Then use the correct length #10 self threading
screws provided from the instructions above to secure the drain to the
pool or spa surface. No spacers will be needed. Apply 24 In-Lbs torque.
4. Align the drain cover support plate (#8) over the ring or sump (Figure
5). The top of the outlet pipe should be recessed a minimum of 1 inch
from the back of the plate (Figure 6).
5. Attach the drain cover support plate to the pool or spa surface with
the appropriate screws, fasteners, and spacers as described in 3 above
(Figures 6 or 7). Once installed, be sure that the drain cover support plate
is firmly in place and cannot be pulled out of the pool or spa surface.
If the drain cover support plate is not firmly in place, re-read these
instructions and try another installation method (perhaps 3c above).
Figure 4
Figure 5
Figure 6
810-0256-2017.0521
©2021 Waterway Plastics
