RED FOR HOT
BLUE FOR COLD
H
C
H
C
COMPASS H/C
COMPASS C/H FINISH MATCH
COUNTER
OR SINK
E
F
G
A
C
B
D
1.
2.
3.
4.
4.
Connect and tighten end of
sidespray hose to sidespray hose
tube.
3.
Remove hose cap (E) from end
of sidespray hose tube (F) on
faucet (G).
CONNECTING OPTIONAL SIDE SPRAY
Waterstone faucets are designed for 3 different faucet positions. Handle on left,
front and right. Your faucet is configured for the most common installation (see
below). To reverse this and have the handle positioned on the left, connect the
hose for cold water to the hot supply and the hose for hot water to the cold
supply. This will maintain the relationship of pulling the handle for hot water or
pushing for cold water.
HANDLE ON LEFT
HANDLE IN FRONT
HANDLE ON RIGHT
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
H
C
A
B
C D
A
B
E
E
G
C D
F
F
1.
Before connecting supply hoses,
flush supply stops to clear any debris.
Place a bucket underneath stops and
run water for 5 to 10 seconds. Turn
water off.
2.
Carefully position hot and cold
supplies so they will not interfere with
other hoses.
3.
Connect supply hoses (A) to supply
stops (B). DO NOT use teflon tape or
plumbers putty. Turn water back on
and check for leaks.
CONNECTING SUPPLY HOSES
HANDLE POSITION
OPTIONAL DECORATIVE BUTTONS
(TRADITIONAL ONLY - 3 INCLUDED)
OPTIONAL HOT COLD INDICATOR RING
(CONTEMPORARY ONLY)
1.
To remove, place a small standard screwdriver in the
slot at bottom of metal ring that surrounds the handle
buttons. Gently pry the button from faucet handle.
2.
To replace, position button and snap in with thumb.
1.
To reverse, or remove Hot and Cold Indicator Ring,
unscrew the metal cap, remove ring and flip.
2.
Slide ring back onto handle and screw metal cap
back on.
A
B
1.
Insert side spray base (A) into
side spray hole on your sink or
counter. No plumbers putty is
required. O-ring seals base. Slide
washer (B), thread attaching nut
(C) and securely tighten.
2.
Slide sidespray hose (D)
through side spray base.