Watersports Innovations boost box WSI 1103, Инструкция по установке и эксплуатации

Страница: 12 / 15

3
Troubleshooting Guide
10
Below are some possible conditions and solutions.
COndITIOn SOlUTIOn
Unit will not turn on.
Unit turns on, but
boat volume does not
change when boat
pulls a rider and lEd
does not flash.
lEd flashes when
boat pulls a rider, but
stereo volume does
not increase.
Volume is slow to
return to normal
volume when boat
slows down.
Boat stereo volume is
increased when boat
is not pulling a rider.
NOTe: the Boost Box is intended for use controlling the boat
stereo when pulling waterskiers, wakeboarders, or wakesurfers.
Because the Boost Box works by sensing the boat’s acceleration
and deceleration, it may turn down inadvertently if used during
aggressive deceleration when towing tube riders. this is normal
and is a limitation of the system.
If you are still having trouble with your Boost Box, please call
Watersport Innovations technical support at (423) 449-9408
or send an email to:
support@watersportinnovations.com
Check to ensure Power Cable is firmly
plugged into Control Unit. Ensure power
cable is properly wired to battery’s 12-
volt DC power.
The Control Unit is not sensing the
boat’s acceleration. It is either mounted
improperly (see pages 2-3, Installation)
or needs to be re-calibrated. To re-
calibrate, wait until the boat is in
relatively flat water (no rolling waves)
and turn the unit off and back on.
Ensure Stereo Control Cable is installed
correctly. Check the connection to the
Control Unit. See pages 5-6.
Unit may need to be re-calibrated. Turn
the unit off and back on.
This should be
necessary only if the unit was turned on in
rough water or if the boat’s load changes
significantly (loading fat-sacks, etc.).
Unit may need to be re-calibrated. Turn
the unit off and back on.
This should be
necessary only if the unit was turned on in
rough water or if the boat’s load changes
significantly (loading fat-sacks, etc.).