Setting UP
INstallation and Operation
Installation
1.
Attached
Hoisting Rope (if desired) - In order to adjust the position of the pump on a
surface like a pool cover the included hoisting rope can be attached to the front loop
of the pump.
2.
Connect the adapter
- The HydraPump® Smart Duo comes with an outlet adapter for
connection to a garden hose or other piping. Please see the adapter connections
section for more details.
3.
Insert the Check Valve
(if required) - An optional check valve is included in
application where water is needed to be stopped from coming back into the pump via
the outlet.
4.
Ensure a tight seal
- When attaching to a garden hose make sure that the garden
hose has a washer present to ensure a watertight seal.
5.
Check for kinks
- Make sure that the hose or piping does not have kinks.
6.
Place upright
on a hard, flat surface in the water. Do not set the pump directly on
muddy or sandy surfaces since this could cause the inlet screen to clog or the pump
not to function.
7.
Plug in pump
- Once the pump has been piped and properly put into position, plug
the pump into a 120V GFCI outlet.
Automatic Operation
To operate the pump in automatic mode turn the front switch to
ʻ
Auto
ʼ
mode:
The pump will operate until the water returns to approximately a depth of 1 inch above the
hard surface that the pump is placed on. Once passed below the 1 inch mark HydraDetect™
will allow the pump to continue to pump for an additional 15 seconds. The pump should not
restart until there is at least 1 inch of water present.
04
