Waterpik Water Flosser WP-462, Руководство пользователя

Страница: 7 / 12

7
E
N
G
LI
S
H
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water
Flosser by sliding pressure control on the handle.
Start with the lowest setting and increase to
your liking.
Recommended Technique
Lean low over sink and place tip in mouth. Aim
the tip toward gumline, and turn the unit ON (I).
For best results, start with the back teeth and
work toward the front teeth. Glide tip along
gumline and pause briefly between teeth. Continue until you have cleaned
the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline.
Slightly
close lips to avoid splashing but allow water to flow freely from mouth
into the sink. Keep unit upright during use for best results.
Charging Unit Prior to First Use
Plug the cord into any standard electrical outlet. Make
sure you push the switch into the “OFF” position
before charging. The unit will not charge if the switch
is in the “ON” position. The Waterpik
®
Water Flosser
will stay charged for up to 2 weeks depending on use.
Filling the Reservoir
Remove the charger from the unit prior to
filling reservoir and product use. Lift flip
top on reservoir and fill the reservoir with
lukewarm water.
Inserting and Remove Tips
Insert tip into the center of the knob at the top
of the Water Flosser handle. Press firmly until
the tip clicks into place. To remove the tip from the handle,
press the tip eject button and pull tip from the handle.
CAUTION: Do not press tip eject button while unit
is running.
GETTING STARTED
Tip
Eject
Button
Pressure
Setting