Waterous Pressure Governor, Инструкция по установке и эксплуатации

Страница: 49 / 53

49
|
53
Safety Introduction Product Overview Installation Operation
High-Idle Mode
1
2
Use the illustration and instructions to understand
the high-idle mode. High-idle mode raises the
engine idle speed to a set-point sufficient to charge
a depleted battery. High-idle mode is available
when the Throttle Ready input is active, and the
Pump Engaged and OK To Pump inputs are
inactive, when the OK to pump setting is configured
to NORMAL. The mode is activated when high-idle
pin is active, and the battery system is below
12.5VDC.
Configure the settings to adjust the parameters that
effect the high-idle speed mode. Refer to:
"Configuring the Pressure Governor" on page
35 .
1 Apply an active signal to the high-idle pin.
2 The mode is activated when the battery system
is below 12.5VDC and the appropriate interlock
conditions exist.