For all servicing needs, please contact CUSTOMER SERVICE on:
FREECALL: 1800 800 919 PHONE: 08 6217 0600 FAX: 08 6217 0699 EMAIL: [email protected]
www.aldertapware.com.au www.vitobertoni.com.au
V05 171017
INSTALLATION: QAAD WALL BASIN / BATH SET W/- BACK PLATE
Diagram #1 Mark desired position of wall set and fit screw on left hand side of install plate
Diagram #2
With the DOTTED LINE on the wall mixer cover at the 12 O’CLOCK POSITION, use levelling
tool as shown and mark the right-hand side screw hole
Diagram #3 Fit screw on right hand side
– check level – fit two additional screws in center for stability
Diagram #4 Remove PLASTIC GUIDE to complete tiling
Diagram #5 After tiling, push 5MM PLASTIC SPACER over 19BP Elbow (5mm PLASTIC SPACER can be
found in rear of WALL PLATE)
– use NIPPLE CUTTER* (see below) to reduce length of 19BP Elbow to a
5MM PROTRUSION FROM THE TILE FACE
Diagram #6 Remove 5MM PLASTIC SPACER and assemble CONNECTOR onto the 19BP Elbow
– screw
CONNECTOR up to tile face
Diagram #7 Install WALL PLATE
Diagram #8 Complete assembly by attaching handle and spout as shown
* Recommended NIPPLE CUTTER
– Reliance Worldwide Product Code A60-001
