Assembly and Operating Instructions Sand Filter System without Pre-filter
English
9
Important instructions
•
The use of filter systems for swimming pools
and their protected areas is only permitted if
they are designed and constructed in accor-
dance with VDE 0100-49D. It is mandatory to
protect the power connection via an residual
leakage circuit breaker.
• In order to maintain the required protected
area (removal of electronic equipment from
water), the filter system must be positioned
outside the water with a minimum distance
of 3 m. (Protected area 2 according to VDE
0100-702.)
• Further safety instructions can be found in
the enclosed operating instructions for the
pump. These must be observed! (The CE
label is also included).
To avoid damage:
•
Never let the pump run dry (the filter system
must be installed and the suction hose
filled with water before commissioning).
The connection to the pool skimmer and to
the inlet nozzle must be completed before
commissioning.
•
Actuate the 6-way valve only when the pump
is switched off!
•
Filter systems with non-self-priming pump
must be installed below the water level.
TABLE OF CONTENTS
1. Filter system – Description
1.1 Description of 6-way valve
1.2 Description of circulation pump
1.3 Description of filter tank
2. Commissioning
2.1 Assembly Instructions - Assembly
2.2 Filling the quartz sand filter
2.3 Filling water in - Commissioning
2.4 Flushing the quartz sand
2.5 Filter – Operation
2.6 Setting the filtration time
2.7 Connection of sand filter system
3. Regular backwash
3.1 Backwash
3.2 Rinse
4 Maintenance works
4.1 Maintenance of filter tank
4.2 Maintenance of circulation pump
4.3 General maintenance
5 Taking out of operation
6. Troubleshooting
6.1 Pump not priming
6.2 Insufficient performance of circulation pump
6.3 Circulation pump is too noisy
6.4 Circulation pump does not start automatically
6.5 Circulation pump leaks
6.6 Sand in the pool
6.7 Filter pressure is not correct
6.8 Water is not clear
6.9 Pool loses water
7. Water treatment –
General Information
7.1 pH value
7.2 Algae control
7.3 Error/fault
7.4 Continuous disinfection
7.5 Turbidity
7.6 Causes of unsatisfactory condition of water
COMPONENTS OF THE FILTER SYSTEM
