background image

 

WLH2 Classe

 Manual 

                                                      Page 5 – Revision: 3-2-2021 

 

WARNING!

  

DO NOT OPERATE IF DAMAGED.

  Unplug and isolate water supply if abnormal 

conditions exist. Contact Waterlogic or authorized dealer for repair, service, and installation 

to avoid hazards.  

WARNING! 

CONNECT TO POTABLE WATER SUPPLY.

  This system is to be used for water only 

and is not intended for use where water is microbiologically unsafe or with water of unknown 

quality without adequate disinfection before or after the system. 

 

WARNING!  

TIP HAZARD.  

Dispenser could tip or fall causing serious injury.  Always install 

unit on a firm, flat, and level surface and secure unit to cabinet, wall, or floor if needed.  

Never place heavy items on top of unit and never climb, stand, or hang on unit or storage 

cabinet to prevent injury and damage. 

 

WARNING!

  

UNIT IS HEAVY.  TWO PERSON LIFT REQUIRED.  

Transport unit empty and 

always use material handling equipment or two people with proper lifting technique to 

reduce injury risk. 

 

 

       WARNING!

  

STORE AND TRANSPORT UNIT EMPTY. 

  

ALWAYS SANITIZE BEFORE USE. 

The unit must be 

completely drained 

before storing to avoid stagnation and reduce 

microbiological contamination (potential bacterial growth).  Always sanitize before use to 

eliminate any potential microbiological contaminates.

 

 

CAUTION!

  

INDOOR USE ONLY.   

Intended for Household Use.

  

Never expose to direct 

sunlight, heat sources, or ambient air temperature above 37°C (100°F) or below 2°C (35°F).  

Install indoors and keep unit away from excessive humidity.  Never expose to freezing 

temperatures.  Ensure there is adequate clearance around the unit to allow refrigeration 

system condenser to dissipate heat.  Warmer environments require more clearance around 

the unit.  Minimum clearance around all surfaces of the machine is 2-inches.  Installs where 

the ambient temperature exceeds 27°C (80°F), require a minimum of 4-inches clearance for 

proper heat dissipation and efficient operation.    

 

CAUTION!

  

USE A WATER PRESSURE REGULATOR. Waterlogic

 will not be responsible for 

injury or damage caused by excessive water pressure.  Input or feed pressure must be 40 psi 

to 60 psi.  Be aware of any potential pressure surges caused by building/municipal pumping 

stations.   

 

CAUTION!

  

USE UV STABILIZED SUPPLY LINES.  

Feed the unit with a potable ambient or cold 

water supply only.

  

Feed water over 37°C (100°F) can damage the treatment components.  

Water block devices and external leak detectors are strongly recommended. Locate the unit 

as close to the water supply and the electrical connections as possible.  Locate the unit as 

close to the water supply and the electrical connections as possible.  Immediately isolate or 

close water supply valve and contact service representative if leak is noticed. 

 

Contact Waterlogic for assistance or help finding an Authorized Service Representative. 

Содержание WLH2 Classe










Отзывы: