WL15
Manual
Page 10 – Revision: 4-15-22
OPERATION AND LIGHT SIGNALS
UNLOCK DISPENSE BUTTON
Unlocks the dispense
operation, allowing the
water type to be selected.
Press and Release to unlock.
OPERATION LIGHTS
HOT
: Hot water is at desired temperature.
HEATING
: Hot water is being heated to desired temperature.
COLD
: Sparkling and Cold water is at desired temperature.
CHILLING
: Sparkling and Cold water is being chilled to desired
temperature.
DISPENSE BUTTONS
These buttons are used to select and dispense the desired water type. Press and hold
to begin dispensing (after the unlock button has been pressed and released). Release
to end dispensing. From left to right: COLD – HOT – SPARKLING (or AMBIENT)
LEAK DETECTION ALARM
If water leaks inside the machine, a leak detection system will shut down the inlet
solenoid. An audible alarm will sound for 10 seconds accompanied by all four touch
buttons blinking. The buttons will continue to blink and the inlet solenoid will remain
inactive until the leaked water has been dealt with.
The above picture shows the front user interface (UI) and control panel for
the Waterlogic
WL15 Water Dispenser
. The three water selection buttons control what kind of water is
dispensed (Hot/Cold/Sparkling or Hot/Cold/Ambient).
Unlock Dispense Function
: Press and release the unlock (padlock icon) button to unlock the
dispense function. Will default back to locked mode after 10 seconds of inactivity.
Dispense Water
: Place cup or container on the Drip tray as far back as possible. Press and
hold the desired selection button (LED should light up once selected) until water begins to
dispense. To end dispensing, release the water selection button.
