Cleaning
Page
10
of
16
Prepare the Unit
1.
Disconnect the electrical power to the unit and isolate from the
water supply.
2.
Carefully following the manufacturer’s instructions, prepare a
solution of proprietary sanitizing fluid
.
Sanitize the Water System
3. Disconnect flexible water inlet tube from the water supply
and place the end into a container of sanitizing fluid. Flushing
through of sanitising solution can be achieved either using a
pressurised container, or by using a syphon. In the latter case,
the sanitiser fluid needs to be held at a height sufficient to
allow fluid to flow through the chiller. Flush through
approximately 17 fl oz of water to flood the chiller with
sanitizing solution
3.
Leave to stand for period recommended by sanitizer
manufacturer
4.
Follow Routine Clean procedure to clean dispense pipework.
Recommission the Unit
5.
Restore the water supply to the unit and dispense a minimum
of 34 fl oz of water to flush the system of sanitizer.
6.
Restore the electrical supply and allow the unit to complete its
cooling cycle.
