Installation
24.10.2018
11 / 20
Copyright
2018 by: WATERKOTTE GmbH Subject to changes.
6
Installation
The compact domestic water heater is mounted to the wall. The screws
and dowels for wall mounting are provided. The hydraulic connections of
the domestic water heater are located at the bottom.
The position of the drill holes are shown in Figure 3.
Figure 3: Drilling template compact domestic water heater
Procedure:
Remove the 4 buttons head socket screws located at the side of the
unit.
Remove the front panel.
Drill two holes with the corresponding distance (see drilling template).
Ensure that the unit is mounted horizontally.
Insert the provided dowels into the drill holes, and screw in the provided
screws, leaving approx. 5 mm to protrude.
Hang the unit and fasten it with the screws to the wall.
After the hydraulic connections are established, mount the front panel
and secure it with the button head socket screws.
6.1
Environmental conditions for installation
The domestic water heater is intended for internal use. The room must be
dry. Room temperature should be b10 °C and +30 °C.
6.2
Temperatures (primary side / forward)
The temperatures on the primary side should be limited to 60 ° C. This re-
duces significantly the risk of calcification and ensures scalding protection.
In addition, the heat losses can be reduced through the pipelines which eg
realizes a higher heat utilization with solar thermal systems. To limit the tem-
perature, we recommend installing a thermostatic mixing valve at the exit of
the hot water tank.
