WaterGroup 185HE SIMTAN, Руководство пользователя

Страница: 5 / 28

5

Place the softener as close as possible to
the pressure tank (well system) or water
meter (city water).

Place the softener as close as possible to a
floor drain, or other acceptable drain point
(laundry tub, sump, standpipe, etc.).

Connect the softener to the main water
supply pipe BEFORE the water heater. DO
NOT RUN HOT WATER THROUGH THE
SOFTENER. Temperature of water pass-
ing through the softener must be less than
100 deg. F.

Keep outside faucets on hard water to
save soft water and salt.

Do not install the softener in a place where
it could freeze. Damage caused by
freezing is not covered by the war-
ranty.

Put the softener in a place water damage
is least likely to occur if a leak develops.
The manufacturer will not repair or pay for
water damage.

A 120 volt electric outlet, to plug the in-
cluded transformer into, is needed within 6
feet of the softener. The transformer has
an attached 6 foot power cable. Be sure
the electric outlet and transformer
are in an inside location, to protect
from wet weather.

If installing in an outside location, you
must take the steps necessary to assure
the softener, installation plumbing, wiring,
etc., are as well protected from the ele-
ments, contamination, vandalism, etc., as
when installed indoors.

Keep the softener out of direct sun-
light. The sun’s heat may soften and dis-
tort plastic parts.
Where To Install The Softener
Optional
Neutralizer
Filter
Note: Neutralizing
filter could be required
to correct a low pH
condition from the
HIMTLC. This can be
determined by a prop-
er water analysis in-
cluding Alkalynity.
Whole House Filter
Filter