Step 4:
Connect Tubing
1.
Install the Inlet Water Tubing
•
Connect the inlet water tubing from the feed water adapter to the inlet water port
and pop the lock clip on the fitting;
Note:
Make sure it is fully inserted until you reach the mark on the tubing.
Note:
Confirm the tubing length you need and cut the tubing if it’s too long,
referring to “How to Use the Quick-Connect Fittings” on page 4.
8
2.
Install the Outlet Water Tubing
Quick-connect
Fitting on Faucet
Lock Clip
Outlet Water Tubing
Feed Water Adapter
3/8
"
Inlet Water Tubing
Inlet Water Port
Inlet Water
Tubing
•
Connect the outlet water tubing from the faucet to the outlet water port and pop
the lock clip on the fitting;
Note:
Make sure it is fully inserted until you reach the mark on the tubing.
Outlet Water Port
Lock Clip
Outlet Water Tubing
Step 5:
Start up the System
1.
Turn on the cold water supply valve. Check for leaks.
2.
Touch one of the filter reset buttons slightly to start up all indicators and check
the display status. The filter life indicator will be off after 10 seconds (Figure 7).
3.
Turn on the faucet to flush for 10 minutes. The indicators will flash if you press
the filter reset button. The indicators will be on after the flushing.
Note:
Be sure to carefully check the tightness of each part of the system while
flushing. Check and ensure all tubings are installed correctly and completely.
Make sure there is no leaking at joints, fittings, valves, and tubing connections.
Note:
The water is undrinkable during flushing for consecutive 10 minutes. If
the flushing is interrupted, it will continue flushing when you turn on the faucet
