StoRING tHE PoWER coRD
1.
Unplug the power cord from the power supply.
2.
Hold the power cord close to the cleaner. Refer Figure A.
3.
Make a roughly half metre (two feet) loop with the power cord as shown. Refer Figure B.
4.
When making loops, roll the power cord slightly in a counter clockwise manner
to maintain form as shown in Fig C.
Note:
Do not loop the power cord tightly around objects.
Note:
When looping the power cord for storage it is best to start close to the cleaner rather
than at the power connection end. Refer Figure A. Hold the power cord as close to the cleaner as possible
and loop the power cord to the cleaner. Refer Figure B & C
GENERaL MaINtENaNcE GUIDE
To ensure the maximum life of the R120, please follow the procedures below:
1. Clean The R120’s filter bag after every use.
2. Maintain a correct chemical balance of your pool/spa water. The chemical balance of water
is a relationship between its pH, total alkalinity, calcium hardness and water temperature.
The water must be maintained at all times to the following:
PH LEVEL: BETWEEN 7.2 & 7.8.
TOTAL ALKALINITY: BETWEEN 80 & 150ppm.
CALCIUM HARDNESS: BETWEEN 150 & 300ppm.
Also, within these tolerances be balanced to the Langelier Saturation Index within a range of -0.2 to +0.2.
Note:
Testing kits are available to test the water yourself or alternately bring a sample of the water to
a professional pool and spa shop.
n
Mains water and rural water supplies need to be monitored. Saturation (life) in mains water or
bore (rural) will vary depending on water quality.
WINtER StoRaGE
If temperatures will regularly be below 5ºC (41ºF) or over 45ºC (113ºF), the cleaner and power supply
(transformer) should be stored indoors.
WaRRaNtY
The R120 has been manufactured, tested and inspected in accordance with carefully specified engineering requirements. It is warranted to
be free from defects in materials and workmanship under normal use and service, subject to qualifications, conditions and limitations
described below.
1 Year Limited Warranty:
One year full warranty, this includes drive motor and pump motor. This warranty applies only while using this product in Australia & New Zealand.
This warranty extends to the first consumer/purchaser for a period of 1 year from the original date of purchase.
This warranty covers only normal and reasonable use. Any damage, defects, malfunctions or other failures arising from its use without the
original transformer or any use which does not comply with the instructions in this manual, including failure of the purchaser to provide
reasonable and necessary maintenance, will void this warranty.
The warranty obligations of Waterco Ltd shall be limited to repair or replacement of the product or any defective component, at the discretion
of Waterco Ltd. The repair or replacement may include the use of refurbished components and/or units. Waterco Ltd will not be liable or
responsible under any circumstances or in any amount for any consequential or incidental damages, for any injury or damages to persons or
property using or used in connection with this product, or for loss of profits or other costs or expenses of any kind or character.
8
Figure A
Figure B
Figure C
Содержание R120
Страница 14: ...14 NOTES ...
Страница 15: ...15 NOTES ...
