Contents
Installation
Connecting counter top filter
1
Unscrew the end cap on the end of your faucet.
2
If the thread on the end of your faucet is on the inside, screw in the wider
diameter of the supplied hexagonal thread adapter (8) into faucet end and
hand tighten. Otherwise proceed to step 3.
3
Screw on the chrome plated faucet end (7) either onto the hexagonal thread
adapter or directly onto faucet end. Hand tighten.
4
Unscrew the round threaded nut (9) off the inlet spout on the chrome
plated faucet end and attach to one end of the hose (5), ensuring the open
end of the nut is facing towards faucet end.
5
Push hose firmly onto inlet spout nipple (10) until it is sitting flush against
thread. secure by hand tightening the round threaded nut.
6
Remove
blue locking clip from the filter unit inlet (11) and connect other end
of hose into the filter unit inlet hole until it stops. Apply the blue locking clip
into the inlet to secure hose.
Operating instructions
7
When the control valve (12) on the chrome plated faucet end is in the
down position, the water from the faucet will come directly from the faucet
(unfiltered).
8
When the control valve is rotated 90 degrees, the water will pass through
the two stage filtration unit. Check for leaks and adjust if necessary.
9
Let the system run for a few minutes to flush the filter cartridges.
10
Allow the system to stand for 2 to 3 hours and then flush again for several
minutes. The system now is operational. Water flow reduction usually
indicates clogging of filter cartridges. Filter cartridge should be changed
based on filter changing instructions. The service life will vary due to water
quality and usage.
2
3
4
6
11
1
5
10
7
12
8
internal thread set-up
external thread set-up
1. two stage filtration unit
2. filter cover
3. carbon cartridge filter
4. disruptor cartridge filter
5. hose
6. chrome plated tap spout
7. chrome plated faucet end
8. hexagonal thread adapter
9. round threaded nut
10. inlet spout nipple
11. filter unit inlet
12. control valve
Product technical specifications
Flow rate
1.8L/min
Max. pressure
400 kPa / 60 psi
Filter capacity
3000L
Water source
municipal water
Filter life
6 months*
The water source should be municipal water. Please do not
use groundwater for filtration to avoid reducing filtration
effectiveness and shorter filter service life. Tank water may
require a sediment pre-filter unit attached to tank. Please
contact us for more information.
Faucet set-up
9
