www.waterchef.com
Your WaterChef Countertop System features an
intelligent monitor
™
to take the guesswork
out of cartridge replacement, so you will never discard a cartridge prematurely, or continue
using one that has exceeded its rated capacity. The Intelligent Monitor informs you that the
System is operating at peak performance by blinking
Green
. As the System approaches the
rated capacity of the Cartridge, the System will begin blinking
yelloW
, indicating that you
should purchase a replacement Cartridge if you haven’t already done so. Finally, the System
will begin blinking
reD
, indicating that a new Cartridge should be installed.
5
rePlaCInG tHe CartrIdGe
1. Remove Lid Assembly by turning counterclockwise
until it separates from the Filter Housing. As you
remove the Lid Assembly, the Cartridge will remain
attached to the Lid Assembly.
(fig. K)
2. Hold the Lid Assembly and rotate the Cartridge
counterclockwise to remove. Discard the old Cartridge
with your regular refuse.
(fig. l)
3. Wash the inside of Filter Housing and Lid Assembly
with warm water, a mild dish washing detergent and
a clean cloth.
4. Remove the sanitary plastic wrap from the new
Cartridge. Thread the new Cartridge clockwise onto
the threaded post on the Lid Assembly until you
feel resistance. Make an additional quarter turn.
Do not over-tighten.
(fig. M)
(continued on next page)
Rubber gloves should be worn to avoid direct contact with the
contaminants removed by the used Cartridge.
recommendatIon
Do not use abrasive pads or other abrasive materials to clean the
Filter Housing or Lid Assembly.
cautIon
Be sure to use only genuine WaterChef
®
Replacement Cartridges. Only genuine WaterChef Replacement
Cartridges have been tested and certified by NSF International to insure the performance represented in the
Performance Data Sheet.
Important
K
l
M