WaterBoss 700, Руководство пользователя и инструкция по установке

Страница: 11 / 36

WaterBoss Softener Owner’s Manual 1/14/2011 11
Installation Steps and Start-Up Procedures, Cont.
Step 7
Flush Lines
A. Place the appliance in the Bypass position.
(See Figure 6.)
B. Turn on the main water supply.
C. Open the nearest cold water faucet to flush the
plumbing of any excess soldering flux, air, or any
other foreign material.
D. Return the appliance to Service mode.
Note: To prevent untreated water from entering
your home, remember to not use water inside your
home when the appliance is in Bypass mode.
Remember to return the appliance to Service
mode when you have finished using untreated
water.
Step 8
Check for Leaks
A. Close all faucets.
B. Check all lines and connections for leaks. If leaks
are found:
1. Turn off the main water supply.
2. Open a cold water faucet to depressurize
the lines.
3. Close the faucet to eliminate any siphoning
action.
4. Repair all leaks.
5. Turn on the water supply.
6. Place the appliance in the Service position to
slowly fill the media tank. (See Figure 7.)
7. Open a cold water faucet to purge air out of
the media tank.
8. Close the faucet and recheck for leaks.
Step 9
Plug in the Transformer
A. Connect the transformer power cord to the back of
the controller. (See Figure 8.)
B. Plug the transformer into an appropriate outlet.
C. Ensure that the outlet selected is not operated by
an On/Off switch.
Step 10
Set Up the Controller
A. Program the appliance controller. See Setting the
Controller .
Figure 6: Bypass Position
Figure 7: Service Position
Figure 8: Connect Power Cord